TABLE OF CONTENTS
Products Covered
MobileMustHave Wireless FusionSIM data plans:
- M100
- M100Y
- M500
- MUnlimited
ONLY FOLLOW THIS ARTICLE IF YOUR PLAN PURCHASED EXACTLY MATCHES THE PLAN LISTED ABOVE
Summary
If you are interested in using a MMH Wireless FusionSIM Cellular Data Plan, you will need to set up your desired cellular modem to connect to it. This guide will teach you how to connect to it and stay connected.
Enable InControl
You will need to check that InControl is enabled in your router. Please ensure that your router is set to the following:
Turning on your FusionSIM
Ensure your router is updated to the current firmware. FusionSIM requires up to date firmware to work. If you need to update your firmware, you can do so by following this guide Updating Peplink Firmware
Navigate to the Dashboard tab and select the cellular details button of the modem you wish to connect to your FusionSIM plan.
Scroll down to "SIM card" setting under "Cellular Settings" section. Check the FusionSIM box.
You can use the horizontal scroller to scroll past SIM A and SIM B on the screen to get to the FusionSIM section. The settings below are not needed for activation and connecting, but may be beneficial (for example, if you want to control band selection on the FusionSIM):
Connecting to your FusionSIM
There are a few ways of establishing your link to the FusionSIM, all of which require another internet source that remains active after establishing the link to FusionSIM. Please note that this other internet source is REQUIRED for you to establish your link to the FusionSIM. The FusionSIM alone does not have the ability to establish your Peplink's initial link to the internet which allows the FusionSIM to connect in the first place. There are two different methods for establishing that initial link to the internet and FusionSIM:
Option 1:
You can have FusionSIM and other internet sources in priority 1 at the same time. Having multiple sources in priority 1 will suffice in getting FusionSIM connected and is perfect if you plan on having multiple internet sources running at the same time for load balancing or SpeedFusion.
Option 2:
You can also connect to FusionSIM using the priority system on your dashboard. In this case, you just need your other internet source in any non-disabled priority:
In option 3, you will have FusionSIM as your priority 1 connection and another non-FusionSIM internet source as priority 2. The Peplink will go through a process of attempting to connect to FusionSIM, then the other internet source, then finally fully connecting to FusionSIM.
Please note the following about connecting to FusionSIM:
- The way this technology works, it needs time to establish the link to the FusionSIM. Please allow for up to 15 minutes after powering on and initiating your attempt to connect.
- FusionSIM requires another internet source to stay connected. As shown above, it can exist in standby to do this job and only requires KBs of data to establish the link. That also means that extremely slow internet sources and small data plans both work great as the backup for FusionSIM.
Requesting Assistance
If you feel you are not getting anywhere or there is another issue you can always reach out to our team directly by initiating a ticket here on the support portal or by emailing info@mobilemusthave.com
Thank you for being the best part of MobileMustHave.com!